Balance Chain »

HOME

Perform an inspection once a year.Timely inspections are recommended when close to wear limit.
Move the spindle head (Y-axis) to the measurement position (lower limit).
Identify the part of the chain that runs on the pulley most. (the most used part within the processing range)
If the L2 length (6 pitch length) matches one in the table below, replacement is necessary.

Machine type	Normal pitch	No. of pitches measured	Normal length	Value compared
BTD-200Q, 200QE	25.4	6	152.4	154.7
BTD-200QF	31.75	6	190.5	196.2
BTD-11.R16, R16	25.4	6	152.4	154.7
BTD-11E.R16, R16	25.4	6	152.4	154.7
BTD-13.R22, 13F.R22	31.75	6	190.5	196.2
BTD-110.R13	31.75	6	190.5	196.2
BTD-110.R16	31.75	6	190.5	194.3
BP-110.P20	31.75	6	190.5	194.3
BP-110.P25	31.75	6	190.5	194.3
BP-130.P40	31.75	6	190.5	194.3
BSF	63.5	6	381	392.4
BSF	50.8	6	228.6	235.5
BF	38.1	6	228.6	235.5
BFT	25.4	6	152.4	157
BT	25.4	6	152.4	157
BMC	31.75	6	190.5	196.2
BTN	31.75	6	190.5	196.2